SCRUTINEERING
• Random scrutineering will take place at any time during a meeting. This will be carried out at the beginning of any heat or heats. All the cars in the chosen heat will be checked, if a car is found to be illegal at any point during the meeting that competitor’s points will be scrubbed for that meeting.
• Top Six cars may have their cars opened up and put on the track for every one to scrutinise at the end of the meeting/final.
• Having a magnet effect track there will be checks for magnetraction in the cars at scrutineering or if any car is suspected of having a magnet fitted.
• Weight may be added inside the car only and must be securely fixed with glue or BlueTac (Lead / lead/alloy substitutes only)
• Cars will be checked to ensure all parts used are eligible and all rules are adhered to.
• Motors must remain sealed/un-opened; any evidence of cans being opened will be viewed as tampering with the motor and is illegal.
• Chief Scrutineer’s decision is final.

RACE FORMAT
• Each driver will race once on each lane. Drivers will race in seeded order (seeding will be worked out from the championship table prior to the event). New drivers will be seeded at the bottom of the point’s table.
• The heats will be raced over 2mins/15 laps. At the end of the heats total time is taken to give a qualifying position for the top 12 drivers to move into the Semi finals. The top 3 drivers from each Semi will then race in the final.
• This is a non-magnet championship. Traction magnets are NOT allowed.

CHAMPIONSHIP FORMAT
• Best 5 of 6 rounds will count.
• In the event of a tie the result will be decided by count-back. ie the drivers with the greater number of 1st, 2nd, 3rd etc. In the unlikely event that there is still a tie all 5 rounds will count.
• The points are as follows:
Heats: 15pts, 14pts, 13pts
Finals: 15pts, 14pts, 13pts

BODIES
Have to remain Standard.(i.e no chopping or lowering of the body)
Extra Aesthetical detailing may be added

CHASSIS
Chassis must remain standard. (i.e. no chopping or lowering of the chassis) except for filing the guide area out to allow fitment of a deep wood guide. (SICH07)
Axle bearing must be fit as intended.
Brackets may be fabricated to allow fitment of motor.
Motor must fit as intended and not protrude from the bottom of the chassis intentionally.
Front axle may be stiffened. (i.e. Brass tuing may be glued into the chassis)

WHEELS
SIPA20 F1 Slot it Rear wheels
SIPA33al/PL or PSRW Scalextric Small Wheels may be used.

TYRES
Must be unglued and untrued. The tread should be visible around the entire circumference of the tyre as one.
SIPT23 P5 F1 Rear Tyres
PSRT Scalextric Small Slicks

FREE CHOICE
Axles
Bearing
Guides
Pinions
Motors

Only Parts from the following manufactures may be used
Slot it
Scalextric
NSR
Scaleauto
MB Slot
All parts used to build the car must remain standard and used as intended.

DIMENTIONS
70mm Max rear axle width
65mm Max Front axle width

ELIGIBLE CARS
Ref Description
C025 Ferrari 312 B2
C026 March Ford 721
C050 Lotus JPS 72
C121 Tyrell Ford
C126 Lotus JPS 77
C129 March 771 6 Wheeler
C134 Renault RS03
C135 Elf Tyrell 008
C136 Ferrari 312 T3
C137 Ligier JS-11
C138 Saudia Williams
C139 Brabham BT49b
The list above is only a guide but cars must be passed by the scrutineers before being allowed to race.